Привет при обновлении прошивки zigbee сетервого адапетар zigstar

моргнул свет
В логах при повторной поытке
[11:28:01] INFO: Starting CC2652P flasher with socket://192.168.1.6:6638
Setting filename to /root/firmware.hex
Opening port socket://192.168.1.6:6638, baud 500000
Reading data from /root/firmware.hex
Your firmware looks like an Intel Hex file
Connecting to target...
pg_rev = 3, protocols = f, wafer_id = 0xbb41
CC135x PG2.0 (7x7mm): 352KB Flash, 20KB SRAM, CCFG.BL_CONFIG at 0x00057FD8
Primary IEEE Address: 00:12:4B:00:25:79:15:75
Performing mass erase
Erasing all main bank flash sectors
Erase done
Writing 360448 bytes starting at address 0x00000000
Write 248 bytes at 0x00000000
Write 248 bytes at 0x000000F8
Write 248 bytes at 0x000001F0
Write 248 bytes at 0x000002E8
Write 248 bytes at 0x000003E0
ERROR: No response from target on status request. (Did you disable the bootloader?)
[11:28:07] INFO: cc2652-flasher-up script exited with code 1
s6-rc: warning: unable to start service cc2652-flasher: command exited 1
s6-rc: info: service banner: stopping
/run/s6/basedir/scripts/rc.init: warning: s6-rc failed to properly bring all the services up! Check your logs (in /run/uncaught-logs/current if you have in-container logging) for more information.
/run/s6/basedir/scripts/rc.init: fatal: stopping the container.
s6-rc: info: service banner successfully stopped
s6-rc: info: service legacy-cont-init: stopping
s6-rc: info: service legacy-cont-init successfully stopped
s6-rc: info: service fix-attrs: stopping
s6-rc: info: service fix-attrs successfully stopped
s6-rc: info: service s6rc-oneshot-runner: stopping
s6-rc: info: service s6rc-oneshot-runner successfully stopped

Есть вариант спасти железку?

j-tag программатор.

А можно чуть поподробнее или ссылочку на мануал